An adaptive internal mass source wave-maker for short wave generation

The mass source wave-maker is commonly employed for generating water waves in numerical simulations, during which a correct amount of mass is introduced or subtracted from the internal flow region to produce target waves. The method has proven to be effective in producing waves in shallow and intermediate water depths, while its efficiency is declined for short wave generation. The main reason for this efficiency declination is that the internal mass source in deeper water region is not effective to generate short waves with their motions primarily on water surface. In order to overcome this shortcoming, many of the previous numerical treatments have introduced various enhancement factors into the source functions, which are empirically obtained and also violate the law of mass conservation. In this study, we develop a new adaptive internal wave-maker model that can be self-adjusted to suit different wave conditions. The line source starts from the bottom and extends to the computational cell right beneath free surface at each time step. The depth dependent weighting coefficient is introduced to the source function based on the linear wave theory for each wave component. No empirical coefficients are necessary, and the mass conservation is strictly and explicitly enforced. In principle, the method can be applied to all types of linear waves in the entire range of kh. The numerical experiments show that the present method can produce very good results for linear waves with kh up to 16.11, adequate for most of wave conditions in coastal engineering. For generation of fifth-order Stokes waves, the method can be extended straightforwardly for each of five wave components. For irregular waves composed of many linear wave components, different weighting coefficients can be readily calculated for each of them, respectively. As a result, the new model can generate irregular waves with overall better performance of reproducing wave spectrum, whose high-frequency part has been underestimated by previous methods. The numerical experiments also show that the new model can produce better results for focused waves where many linear waves of different frequencies start from the same point with specific phase angles, due to its capability of generating shorter wave components.