弹性塑料板在反复冲击载荷作用下发生晃动

IF 5 2区 工程技术 Q2 MATERIALS SCIENCE, MULTIDISCIPLINARY Journal of The Mechanics and Physics of Solids Pub Date : 2024-10-21 DOI:10.1016/j.jmps.2024.105918
{"title":"弹性塑料板在反复冲击载荷作用下发生晃动","authors":"","doi":"10.1016/j.jmps.2024.105918","DOIUrl":null,"url":null,"abstract":"<div><div>When subjected to repeated dynamic impacts at identical load level, a metallic monolithic beam/plate may reach a stable state wherein measurable deformation ceases (i.e., shakedown in elastic state) after undergoing a sequence of elastoplastic deformations, which has been termed as “pseudo-shakedown” (P-S) (Jones, 1973; Shen and Jones, 1992). While the response of a single beam/plate under repeated <em>low-velocity</em> impacts has been thoroughly studied, its dynamic behavior under <em>high-velocity</em> impacts, such as explosive or alternating impulsive loads, is difficult to measure experimentally, due mainly to high costs and setup challenges. In the current study, the method of metallic foam projectile impact was employed to produce repeated impulsive loadings on a fully-clamped elastoplastic monolithic plate made of L907A (a Chinese standard shipbuilding steel). Its dynamic responses, including mid-point deflection versus time histories, final deflections, and deformation modes after each impact, were systematically measured. The phenomenon of dynamic shakedown was observed. To further explore this phenomenon, the method of finite elements (FE) was employed to simulate the repeated impulsive impact test, and its prediction accuracy was validated against experimental results. Unlike an elastoplastic (e.g., steel) monolithic plate subjected to repeated <em>low-velocity</em> impacts, which exhibits zero plastic energy dissipation in the P-S (pseudo-shakedown) state, the same plate under repeated <em>high-velocity</em> impacts shows a small level of plastic energy dissipation in the P-S state, mainly due to more extreme loading conditions. The initial impact momentum, yield strength, and tangent modulus of the material the plate is made of significantly affect both the stable deflection in the P-S state and the number of impacts needed to reach it, while the elastic modulus has limited influence. A modified dimensionless impulse loading number, accounting for the strain-hardening effect, is proposed. An approximately linear relationship between stable deflection in the P-S state and impulsive loading is found in dimensionless form.</div></div>","PeriodicalId":17331,"journal":{"name":"Journal of The Mechanics and Physics of Solids","volume":null,"pages":null},"PeriodicalIF":5.0000,"publicationDate":"2024-10-21","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":"0","resultStr":"{\"title\":\"Elastoplastic plate shakes down under repeated impulsive loadings\",\"authors\":\"\",\"doi\":\"10.1016/j.jmps.2024.105918\",\"DOIUrl\":null,\"url\":null,\"abstract\":\"<div><div>When subjected to repeated dynamic impacts at identical load level, a metallic monolithic beam/plate may reach a stable state wherein measurable deformation ceases (i.e., shakedown in elastic state) after undergoing a sequence of elastoplastic deformations, which has been termed as “pseudo-shakedown” (P-S) (Jones, 1973; Shen and Jones, 1992). While the response of a single beam/plate under repeated <em>low-velocity</em> impacts has been thoroughly studied, its dynamic behavior under <em>high-velocity</em> impacts, such as explosive or alternating impulsive loads, is difficult to measure experimentally, due mainly to high costs and setup challenges. In the current study, the method of metallic foam projectile impact was employed to produce repeated impulsive loadings on a fully-clamped elastoplastic monolithic plate made of L907A (a Chinese standard shipbuilding steel). Its dynamic responses, including mid-point deflection versus time histories, final deflections, and deformation modes after each impact, were systematically measured. The phenomenon of dynamic shakedown was observed. To further explore this phenomenon, the method of finite elements (FE) was employed to simulate the repeated impulsive impact test, and its prediction accuracy was validated against experimental results. Unlike an elastoplastic (e.g., steel) monolithic plate subjected to repeated <em>low-velocity</em> impacts, which exhibits zero plastic energy dissipation in the P-S (pseudo-shakedown) state, the same plate under repeated <em>high-velocity</em> impacts shows a small level of plastic energy dissipation in the P-S state, mainly due to more extreme loading conditions. The initial impact momentum, yield strength, and tangent modulus of the material the plate is made of significantly affect both the stable deflection in the P-S state and the number of impacts needed to reach it, while the elastic modulus has limited influence. A modified dimensionless impulse loading number, accounting for the strain-hardening effect, is proposed. An approximately linear relationship between stable deflection in the P-S state and impulsive loading is found in dimensionless form.</div></div>\",\"PeriodicalId\":17331,\"journal\":{\"name\":\"Journal of The Mechanics and Physics of Solids\",\"volume\":null,\"pages\":null},\"PeriodicalIF\":5.0000,\"publicationDate\":\"2024-10-21\",\"publicationTypes\":\"Journal Article\",\"fieldsOfStudy\":null,\"isOpenAccess\":false,\"openAccessPdf\":\"\",\"citationCount\":\"0\",\"resultStr\":null,\"platform\":\"Semanticscholar\",\"paperid\":null,\"PeriodicalName\":\"Journal of The Mechanics and Physics of Solids\",\"FirstCategoryId\":\"5\",\"ListUrlMain\":\"https://www.sciencedirect.com/science/article/pii/S0022509624003843\",\"RegionNum\":2,\"RegionCategory\":\"工程技术\",\"ArticlePicture\":[],\"TitleCN\":null,\"AbstractTextCN\":null,\"PMCID\":null,\"EPubDate\":\"\",\"PubModel\":\"\",\"JCR\":\"Q2\",\"JCRName\":\"MATERIALS SCIENCE, MULTIDISCIPLINARY\",\"Score\":null,\"Total\":0}","platform":"Semanticscholar","paperid":null,"PeriodicalName":"Journal of The Mechanics and Physics of Solids","FirstCategoryId":"5","ListUrlMain":"https://www.sciencedirect.com/science/article/pii/S0022509624003843","RegionNum":2,"RegionCategory":"工程技术","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":null,"EPubDate":"","PubModel":"","JCR":"Q2","JCRName":"MATERIALS SCIENCE, MULTIDISCIPLINARY","Score":null,"Total":0}
引用次数: 0

摘要

当金属整体梁/板受到相同荷载水平的反复动态冲击时,可能会达到一种稳定状态,在经历一系列弹塑性变形后,可测量的变形停止(即弹性状态下的抖动),这种状态被称为 "伪抖动"(P-S)(Jones,1973 年;Shen 和 Jones,1992 年)。虽然对单个梁/板在重复低速冲击下的响应进行了深入研究,但其在高速冲击(如爆炸或交变冲击载荷)下的动态行为却很难进行实验测量,主要原因是成本高昂和设置困难。本研究采用金属泡沫弹丸冲击的方法,对由 L907A(中国标准造船钢材)制成的全夹紧弹塑性整体板产生重复冲击载荷。系统测量了其动态响应,包括中点挠度与时间历程、最终挠度以及每次冲击后的变形模式。观察到了动态晃动现象。为了进一步探讨这一现象,采用了有限元(FE)方法来模拟重复的冲击试验,并根据实验结果验证了其预测精度。受到反复低速冲击的弹塑性整体板(如钢板)在 P-S(假抖动)状态下的塑性能量耗散为零,而受到反复高速冲击的同一整体板在 P-S 状态下的塑性能量耗散较小,这主要是由于加载条件更为极端。钢板材料的初始冲击动量、屈服强度和切线模量对 P-S 状态下的稳定挠度和达到稳定挠度所需的冲击次数有很大影响,而弹性模量的影响有限。我们提出了一个考虑到应变硬化效应的修正无量纲冲击加载数。在无量纲形式下,P-S 状态下的稳定挠度与脉冲加载之间存在近似线性关系。
本文章由计算机程序翻译,如有差异,请以英文原文为准。
查看原文
分享 分享
微信好友 朋友圈 QQ好友 复制链接
本刊更多论文
Elastoplastic plate shakes down under repeated impulsive loadings
When subjected to repeated dynamic impacts at identical load level, a metallic monolithic beam/plate may reach a stable state wherein measurable deformation ceases (i.e., shakedown in elastic state) after undergoing a sequence of elastoplastic deformations, which has been termed as “pseudo-shakedown” (P-S) (Jones, 1973; Shen and Jones, 1992). While the response of a single beam/plate under repeated low-velocity impacts has been thoroughly studied, its dynamic behavior under high-velocity impacts, such as explosive or alternating impulsive loads, is difficult to measure experimentally, due mainly to high costs and setup challenges. In the current study, the method of metallic foam projectile impact was employed to produce repeated impulsive loadings on a fully-clamped elastoplastic monolithic plate made of L907A (a Chinese standard shipbuilding steel). Its dynamic responses, including mid-point deflection versus time histories, final deflections, and deformation modes after each impact, were systematically measured. The phenomenon of dynamic shakedown was observed. To further explore this phenomenon, the method of finite elements (FE) was employed to simulate the repeated impulsive impact test, and its prediction accuracy was validated against experimental results. Unlike an elastoplastic (e.g., steel) monolithic plate subjected to repeated low-velocity impacts, which exhibits zero plastic energy dissipation in the P-S (pseudo-shakedown) state, the same plate under repeated high-velocity impacts shows a small level of plastic energy dissipation in the P-S state, mainly due to more extreme loading conditions. The initial impact momentum, yield strength, and tangent modulus of the material the plate is made of significantly affect both the stable deflection in the P-S state and the number of impacts needed to reach it, while the elastic modulus has limited influence. A modified dimensionless impulse loading number, accounting for the strain-hardening effect, is proposed. An approximately linear relationship between stable deflection in the P-S state and impulsive loading is found in dimensionless form.
求助全文
通过发布文献求助,成功后即可免费获取论文全文。 去求助
来源期刊
Journal of The Mechanics and Physics of Solids
Journal of The Mechanics and Physics of Solids 物理-材料科学:综合
CiteScore
9.80
自引率
9.40%
发文量
276
审稿时长
52 days
期刊介绍: The aim of Journal of The Mechanics and Physics of Solids is to publish research of the highest quality and of lasting significance on the mechanics of solids. The scope is broad, from fundamental concepts in mechanics to the analysis of novel phenomena and applications. Solids are interpreted broadly to include both hard and soft materials as well as natural and synthetic structures. The approach can be theoretical, experimental or computational.This research activity sits within engineering science and the allied areas of applied mathematics, materials science, bio-mechanics, applied physics, and geophysics. The Journal was founded in 1952 by Rodney Hill, who was its Editor-in-Chief until 1968. The topics of interest to the Journal evolve with developments in the subject but its basic ethos remains the same: to publish research of the highest quality relating to the mechanics of solids. Thus, emphasis is placed on the development of fundamental concepts of mechanics and novel applications of these concepts based on theoretical, experimental or computational approaches, drawing upon the various branches of engineering science and the allied areas within applied mathematics, materials science, structural engineering, applied physics, and geophysics. The main purpose of the Journal is to foster scientific understanding of the processes of deformation and mechanical failure of all solid materials, both technological and natural, and the connections between these processes and their underlying physical mechanisms. In this sense, the content of the Journal should reflect the current state of the discipline in analysis, experimental observation, and numerical simulation. In the interest of achieving this goal, authors are encouraged to consider the significance of their contributions for the field of mechanics and the implications of their results, in addition to describing the details of their work.
期刊最新文献
Premature jump-to-contact with elastic surfaces Nonlinear soliton spiral induces coupled multimode dynamics in multi-stable dissipative metamaterials Inertia effect of deformation in amorphous solids: A dynamic mesoscale model Elastoplastic plate shakes down under repeated impulsive loadings Strain energy density maximization principle for material design and the reflection in trans-scale continuum theory
×
引用
GB/T 7714-2015
复制
MLA
复制
APA
复制
导出至
BibTeX EndNote RefMan NoteFirst NoteExpress
×
×
提示
您的信息不完整,为了账户安全,请先补充。
现在去补充
×
提示
您因"违规操作"
具体请查看互助需知
我知道了
×
提示
现在去查看 取消
×
提示
确定
0
微信
客服QQ
Book学术公众号 扫码关注我们
反馈
×
意见反馈
请填写您的意见或建议
请填写您的手机或邮箱
已复制链接
已复制链接
快去分享给好友吧!
我知道了
×
扫码分享
扫码分享
Book学术官方微信
Book学术文献互助
Book学术文献互助群
群 号:481959085
Book学术
文献互助 智能选刊 最新文献 互助须知 联系我们:info@booksci.cn
Book学术提供免费学术资源搜索服务,方便国内外学者检索中英文文献。致力于提供最便捷和优质的服务体验。
Copyright © 2023 Book学术 All rights reserved.
ghs 京公网安备 11010802042870号 京ICP备2023020795号-1