A modeling analysis on industrial radial-flow packed-bed reactors for the catalytic dehydrogenation of long-chain normal paraffins: Appraisal of the modeling approach

Catalytic dehydrogenation of long-chain normal paraffins is the most attractive route for producing of linear alkyl benzene. To make this happen, the radial-flow packed-bed reactors are employed as one of the most efficient currently available technologies. Simplifying assumptions that are sometimes imposed on reactor models to reduce the computational cost may also significantly decrease the accuracy of simulations. Here, it is decided to shed light on this matter by assessing the effect of typical model-simplifying assumptions on simulation results. To this end, one- and two-dimensional semi-homogeneous models are used to simulate an industrial-scale radial-flow packed-bed dehydrogenation reactor under isothermal and adiabatic conditions. Simulations are designed in four 1D isothermal, 1D adiabatic, 2D isothermal, and 2D adiabatic modes to compare different modeling strategies and investigate the effect of flow distribution on the reactor performance. An appropriate LHHW kinetics model is considered for paraffin dehydrogenation and the main associated side reactions over a commercial Pt-Sn-K-Mg/γ-Al₂O₃ catalyst. The model equations are solved numerically using the finite element method by COMSOL Multiphysics CFD software. The results show a 1–3 % discrepancy between the predictions of one- and two-dimensional models for feed conversion under isothermal and adiabatic conditions. In contrast, the comparison of isothermal and adiabatic results for each one- and two-dimensional models indicate a discrepancy of 33–36 %. Furthermore, the two-dimensional model shows a low non-uniformity in flow distribution under reaction conditions (∼ 0.175), which has a trivial negative effect on paraffin conversion.