Hybrid rubber‐concrete isolation slab system with various shape factors for structures subjected to horizontal and vertical vibrations

The present framework proposed the development of a Hybrid Rubber‐Concrete Isolation Slab System (HRCISS) to support building structures subjected to horizontal and vertical vibration due to ground motion and machine or equipment operation in the structure. Given that the effect of the shape factor on both horizontal and vertical stiffness has yet to be reported, the proposed composite system was comprised of two layers under the nodal points of the upper layer near the slab corners with four High Damping Rubber (HDR) components positioned between the slab layers to dissipate multidirectional (horizontal and vertical directions) vibrations. The ABAQUS software was utilized to model the finite element model (FEM) and simulate the HRCISS subjected to cyclic horizontal and vertical displacements. For the optimal HDR design, the model was applied in five 3‐story buildings, and the effect of distinct shape factors (0 < S < 2) of the HDR bearings—the ratio of bearing's loaded area to unloaded area (free to bulge)—within the hybrid system was evaluated. For each building with a specific HDR shape factor, the HRCISS was installed in the first, second, and third stories, separately, to investigate the influence of the installation level of the isolation system on the overall structural performance. The multistory buildings were subjected to two types of vibration loads: the interior machine‐induced vibrations, and the exterior seismic‐induced vibrations in the horizontal and vertical directions. Based on the results, the FEM results proved the significant influence of the shape factors on the dynamic response of the HRCISS under both interior and exterior 3D vibrations when applied in multistory buildings. The lateral drift of the three‐story one‐bay buildings decreased with the decrement of shape factor with buildings of HRCISS installed in 1st story recording more reduction. Moreover, the deflection in the structural slab under the HRCISS decreased for lower shape factor bearings. Nevertheless, the reduced deflection was less affected by the level of the machine‐equipped story. The rubber layer also stiffened in shear and compression directions with a higher shape factor.