化学蚀刻法制备多孔二氧化硅纳米颗粒去除水中百草枯

IF 0.6 4区 综合性期刊 Q3 MULTIDISCIPLINARY SCIENCES Chiang Mai Journal of Science Pub Date : 2023-01-31 DOI:10.12982/cmjs.2023.009
Kanokwan Darasoon, Supawitch Hoijang, Tanapong Kunakham, Sorapong Janhom, S. Ananta, Gyu Leem, L. Srisombat
{"title":"化学蚀刻法制备多孔二氧化硅纳米颗粒去除水中百草枯","authors":"Kanokwan Darasoon, Supawitch Hoijang, Tanapong Kunakham, Sorapong Janhom, S. Ananta, Gyu Leem, L. Srisombat","doi":"10.12982/cmjs.2023.009","DOIUrl":null,"url":null,"abstract":"In t his study, solid silica nanoparticles (sSiO2 NPs) were chemically etched using sodium hydroxide solution as an etchant to synthesize porous silica nanoparticles (pSiO2 NPs). Etchant dosage and etching time were optimized to obtain the optimum etching condition providing the effective removal of paraquat (PQ). High removal efficiency of PQ by the synthesized pSiO2 NPs was obtained over 90% using 11.1 mL of 1.25 M NaOH and 12 h for the etching process. SEM and TEM images showed that the porosity of pSiO2 NPs increased with increase of the etchant dosage and etching time. The increment of porosity of pSiO2 NPs enhanced the PQ removal efficiency. FTIR result indicated that the characteristic functionalities of silica remain after the etching process. After optimum condition of etching obtained, the adsorption behavior of PQ was investigated. Several key factors influencing the adsorption efficiency, i.e., initial solution pH, initial concentration, and adsorption time were optimized. The maximum removal efficiency of PQ (~98%) by the pSiO2 nanoadsorbent was obtained using 100 mg L-1 of PQ solution at pH ~7 within 5 minutes. The maximum adsorption capacity (qmax) of the pSiO2 NPs for the PQ removal was 65.7 mg g-1. The pSiO2 nanoadsorbent is effective adsorbent for the PQ removal due to the development of a facile synthetic method for adsorbent preparation, rapid adsorption process, and comparable qmax value with other PQ adsorbents.","PeriodicalId":9884,"journal":{"name":"Chiang Mai Journal of Science","volume":"26 1","pages":""},"PeriodicalIF":0.6000,"publicationDate":"2023-01-31","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":"0","resultStr":"{\"title\":\"Preparation of Porous Silica Nanoparticles by Chemical Etching for Removal of Paraquat from Aqueous Solution\",\"authors\":\"Kanokwan Darasoon, Supawitch Hoijang, Tanapong Kunakham, Sorapong Janhom, S. Ananta, Gyu Leem, L. Srisombat\",\"doi\":\"10.12982/cmjs.2023.009\",\"DOIUrl\":null,\"url\":null,\"abstract\":\"In t his study, solid silica nanoparticles (sSiO2 NPs) were chemically etched using sodium hydroxide solution as an etchant to synthesize porous silica nanoparticles (pSiO2 NPs). Etchant dosage and etching time were optimized to obtain the optimum etching condition providing the effective removal of paraquat (PQ). High removal efficiency of PQ by the synthesized pSiO2 NPs was obtained over 90% using 11.1 mL of 1.25 M NaOH and 12 h for the etching process. SEM and TEM images showed that the porosity of pSiO2 NPs increased with increase of the etchant dosage and etching time. The increment of porosity of pSiO2 NPs enhanced the PQ removal efficiency. FTIR result indicated that the characteristic functionalities of silica remain after the etching process. After optimum condition of etching obtained, the adsorption behavior of PQ was investigated. Several key factors influencing the adsorption efficiency, i.e., initial solution pH, initial concentration, and adsorption time were optimized. The maximum removal efficiency of PQ (~98%) by the pSiO2 nanoadsorbent was obtained using 100 mg L-1 of PQ solution at pH ~7 within 5 minutes. The maximum adsorption capacity (qmax) of the pSiO2 NPs for the PQ removal was 65.7 mg g-1. The pSiO2 nanoadsorbent is effective adsorbent for the PQ removal due to the development of a facile synthetic method for adsorbent preparation, rapid adsorption process, and comparable qmax value with other PQ adsorbents.\",\"PeriodicalId\":9884,\"journal\":{\"name\":\"Chiang Mai Journal of Science\",\"volume\":\"26 1\",\"pages\":\"\"},\"PeriodicalIF\":0.6000,\"publicationDate\":\"2023-01-31\",\"publicationTypes\":\"Journal Article\",\"fieldsOfStudy\":null,\"isOpenAccess\":false,\"openAccessPdf\":\"\",\"citationCount\":\"0\",\"resultStr\":null,\"platform\":\"Semanticscholar\",\"paperid\":null,\"PeriodicalName\":\"Chiang Mai Journal of Science\",\"FirstCategoryId\":\"103\",\"ListUrlMain\":\"https://doi.org/10.12982/cmjs.2023.009\",\"RegionNum\":4,\"RegionCategory\":\"综合性期刊\",\"ArticlePicture\":[],\"TitleCN\":null,\"AbstractTextCN\":null,\"PMCID\":null,\"EPubDate\":\"\",\"PubModel\":\"\",\"JCR\":\"Q3\",\"JCRName\":\"MULTIDISCIPLINARY SCIENCES\",\"Score\":null,\"Total\":0}","platform":"Semanticscholar","paperid":null,"PeriodicalName":"Chiang Mai Journal of Science","FirstCategoryId":"103","ListUrlMain":"https://doi.org/10.12982/cmjs.2023.009","RegionNum":4,"RegionCategory":"综合性期刊","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":null,"EPubDate":"","PubModel":"","JCR":"Q3","JCRName":"MULTIDISCIPLINARY SCIENCES","Score":null,"Total":0}
引用次数: 0

摘要

在本研究中,采用氢氧化钠溶液作为蚀刻剂,化学蚀刻固体二氧化硅纳米颗粒(sSiO2 NPs),合成多孔二氧化硅纳米颗粒(pSiO2 NPs)。通过对蚀刻剂用量和蚀刻时间的优化,获得了能有效去除百草枯的最佳蚀刻条件。采用11.1 mL 1.25 M NaOH溶液和12 h的蚀刻工艺,合成的pSiO2 NPs对PQ的去除率达到90%以上。SEM和TEM结果表明,随着蚀刻剂用量的增加和蚀刻时间的延长,pSiO2纳米颗粒的孔隙率逐渐增大。孔隙率的增加提高了pSiO2 NPs的PQ去除效率。FTIR结果表明,在蚀刻过程中,二氧化硅的特征官能团仍然存在。在获得最佳蚀刻条件后,研究了PQ的吸附行为。优化了影响吸附效率的几个关键因素,即初始溶液pH、初始浓度和吸附时间。当PQ溶液浓度为100 mg L-1, pH ~7时,pSiO2纳米吸附剂对PQ的去除率在5 min内达到最大(~98%)。pSiO2 NPs对PQ的最大吸附量(qmax)为65.7 mg g-1。pSiO2纳米吸附剂制备方法简便,吸附过程快速,qmax值与其他PQ吸附剂相当,是去除PQ的有效吸附剂。
本文章由计算机程序翻译,如有差异,请以英文原文为准。
查看原文
分享 分享
微信好友 朋友圈 QQ好友 复制链接
本刊更多论文
Preparation of Porous Silica Nanoparticles by Chemical Etching for Removal of Paraquat from Aqueous Solution
In t his study, solid silica nanoparticles (sSiO2 NPs) were chemically etched using sodium hydroxide solution as an etchant to synthesize porous silica nanoparticles (pSiO2 NPs). Etchant dosage and etching time were optimized to obtain the optimum etching condition providing the effective removal of paraquat (PQ). High removal efficiency of PQ by the synthesized pSiO2 NPs was obtained over 90% using 11.1 mL of 1.25 M NaOH and 12 h for the etching process. SEM and TEM images showed that the porosity of pSiO2 NPs increased with increase of the etchant dosage and etching time. The increment of porosity of pSiO2 NPs enhanced the PQ removal efficiency. FTIR result indicated that the characteristic functionalities of silica remain after the etching process. After optimum condition of etching obtained, the adsorption behavior of PQ was investigated. Several key factors influencing the adsorption efficiency, i.e., initial solution pH, initial concentration, and adsorption time were optimized. The maximum removal efficiency of PQ (~98%) by the pSiO2 nanoadsorbent was obtained using 100 mg L-1 of PQ solution at pH ~7 within 5 minutes. The maximum adsorption capacity (qmax) of the pSiO2 NPs for the PQ removal was 65.7 mg g-1. The pSiO2 nanoadsorbent is effective adsorbent for the PQ removal due to the development of a facile synthetic method for adsorbent preparation, rapid adsorption process, and comparable qmax value with other PQ adsorbents.
求助全文
通过发布文献求助,成功后即可免费获取论文全文。 去求助
来源期刊
Chiang Mai Journal of Science
Chiang Mai Journal of Science MULTIDISCIPLINARY SCIENCES-
CiteScore
1.00
自引率
25.00%
发文量
103
审稿时长
3 months
期刊介绍: The Chiang Mai Journal of Science is an international English language peer-reviewed journal which is published in open access electronic format 6 times a year in January, March, May, July, September and November by the Faculty of Science, Chiang Mai University. Manuscripts in most areas of science are welcomed except in areas such as agriculture, engineering and medical science which are outside the scope of the Journal. Currently, we focus on manuscripts in biology, chemistry, physics, materials science and environmental science. Papers in mathematics statistics and computer science are also included but should be of an applied nature rather than purely theoretical. Manuscripts describing experiments on humans or animals are required to provide proof that all experiments have been carried out according to the ethical regulations of the respective institutional and/or governmental authorities and this should be clearly stated in the manuscript itself. The Editor reserves the right to reject manuscripts that fail to do so.
期刊最新文献
Drying Characteristics and Mitragynine Content of Kratom Leaves Biodiesel Production from Waste Cooking Oil using Heterogeneous CaO/Zn Catalyst: Yield and Reusability Performance Performance of Solar-based Electrochemical System as Post-treatment of Hospital Wastewater Contaminated with Ciprofloxacin Carbon-supported Ternary Nanocatalyst Palladium-Vanadium-Cobalt for Hydrodechlorination of 2,4-Dichlorophenol Synergistic Effects of Plant Growth-Promoting Microorganisms on Growth and Development of Terap (Artocarpus odoratissimus Blanco) Seedlings
×
引用
GB/T 7714-2015
复制
MLA
复制
APA
复制
导出至
BibTeX EndNote RefMan NoteFirst NoteExpress
×
×
提示
您的信息不完整,为了账户安全,请先补充。
现在去补充
×
提示
您因"违规操作"
具体请查看互助需知
我知道了
×
提示
现在去查看 取消
×
提示
确定
0
微信
客服QQ
Book学术公众号 扫码关注我们
反馈
×
意见反馈
请填写您的意见或建议
请填写您的手机或邮箱
已复制链接
已复制链接
快去分享给好友吧!
我知道了
×
扫码分享
扫码分享
Book学术官方微信
Book学术文献互助
Book学术文献互助群
群 号:481959085
Book学术
文献互助 智能选刊 最新文献 互助须知 联系我们:info@booksci.cn
Book学术提供免费学术资源搜索服务,方便国内外学者检索中英文文献。致力于提供最便捷和优质的服务体验。
Copyright © 2023 Book学术 All rights reserved.
ghs 京公网安备 11010802042870号 京ICP备2023020795号-1