Synchrotron Analysis of Damaged Extraction Sockets Augmented Using a Synthetic Bone Block: A Pilot Study.

Aim: To investigate the dimensional stability and quality of the alveolar ridge augmented using a synthetic bone block (SBB) at damaged extraction sockets.

Materials and methods: Four participants were included in whom socket augmentation was performed using SBB and a collagen membrane. Intraoral scan (IOS) was performed before extraction (baseline), immediately postoperative (IP), and at 6 months (6M). Cone-beam computed tomography (CBCT) was performed at IP and 6M. At 6M, a trephine biopsy was obtained during implant placement and the sample was observed using synchrotron. Profilometric change of soft tissue was measured from the IOS data, hard tissue dimensional change was measured from the CBCT data and the bone quality from synchrotron data.

Results: There were minimal changes in the soft tissue profile between baseline and IP, baseline and 6M, and IP and 6M (0.11±1.08 and 0.02±0.8, and -0.65±0.82 mm3). Horizontal bone width measured at 1 mm increments from the augmented bone crest to 5 mm apically revealed only slight reduction (less than 1 mm) at all levels between IP and 6M. The augmented bone height was well maintained from IP until 6M (-0.21±0.53 mm). Synchrotron analysis revealed low to moderate bone quality after 6M (percentage new bone = 16.49±4.91).

Conclusions: Augmentation of the damaged extraction socket using SBB is a viable technique, in which the dimensions of the augmented ridge can be maintained up to 6M. Further long term randomized clinical trial is needed.