A low out-of-band noise LTE transmitter with current-mode approach

Nicola Codega, A. Liscidini, R. Castello
{"title":"A low out-of-band noise LTE transmitter with current-mode approach","authors":"Nicola Codega, A. Liscidini, R. Castello","doi":"10.1109/ESSCIRC.2013.6649128","DOIUrl":null,"url":null,"abstract":"A 55nm CMOS current-mode transmitter for multistandard wireless communications (including LTE) that requires only 1.5mm2 (with 4 output ports) is presented. The circuit is made up of two portions: a class A/B up-converter and a baseband that includes DAC, VGA, low-pass filter (two Biquad plus a passive first order) and class A/B signal conditioner. Combining a third order filter with the class A/B conditioner results in a reduction of both current consumption and RX-band noise injection. For LTE10, the consumption is 96mW and 34mW at 4dBm and at -10dBm output power, respectively. The complete transmitter gives -158dBc/Hz RX-band noise injection at 30MHz offset.","PeriodicalId":183620,"journal":{"name":"2013 Proceedings of the ESSCIRC (ESSCIRC)","volume":"1 1","pages":"0"},"PeriodicalIF":0.0000,"publicationDate":"2013-10-31","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":"3","resultStr":null,"platform":"Semanticscholar","paperid":null,"PeriodicalName":"2013 Proceedings of the ESSCIRC (ESSCIRC)","FirstCategoryId":"1085","ListUrlMain":"https://doi.org/10.1109/ESSCIRC.2013.6649128","RegionNum":0,"RegionCategory":null,"ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":null,"EPubDate":"","PubModel":"","JCR":"","JCRName":"","Score":null,"Total":0}
引用次数: 3

Abstract

A 55nm CMOS current-mode transmitter for multistandard wireless communications (including LTE) that requires only 1.5mm2 (with 4 output ports) is presented. The circuit is made up of two portions: a class A/B up-converter and a baseband that includes DAC, VGA, low-pass filter (two Biquad plus a passive first order) and class A/B signal conditioner. Combining a third order filter with the class A/B conditioner results in a reduction of both current consumption and RX-band noise injection. For LTE10, the consumption is 96mW and 34mW at 4dBm and at -10dBm output power, respectively. The complete transmitter gives -158dBc/Hz RX-band noise injection at 30MHz offset.
查看原文
分享 分享
微信好友 朋友圈 QQ好友 复制链接
本刊更多论文
低带外噪声LTE发射机与电流模式的方法
提出了一种适用于多标准无线通信(包括LTE)的55nm CMOS电流模式发射器,该发射器只需要1.5mm2(带有4个输出端口)。该电路由两部分组成:a /B类上转换器和基带,包括DAC, VGA,低通滤波器(两个双源加一个无源一阶)和a /B类信号调节器。将三阶滤波器与a /B类调节器相结合,可以降低电流消耗和rx波段噪声注入。对于LTE10,在4dBm和-10dBm输出功率下的功耗分别为96mW和34mW。完整的发射机在30MHz偏移时提供-158dBc/Hz的rx波段噪声注入。
本文章由计算机程序翻译,如有差异,请以英文原文为准。
求助全文
约1分钟内获得全文 去求助
来源期刊
自引率
0.00%
发文量
0
期刊最新文献
A 180nm fully-integrated dual-channel reconfigurable receiver for GNSS interoperations A 40 nm LP CMOS self-biased continuous-time comparator with sub-100ps delay at 1.1V & 1.2mW MEMS for automotive and consumer electronics A resistor-based temperature sensor for MEMS frequency references A 13.2% locking-range divide-by-6, 3.1mW, ILFD using even-harmonic-enhanced direct injection technique for millimeter-wave PLLs
×
引用
GB/T 7714-2015
复制
MLA
复制
APA
复制
导出至
BibTeX EndNote RefMan NoteFirst NoteExpress
×
×
提示
您的信息不完整,为了账户安全,请先补充。
现在去补充
×
提示
您因"违规操作"
具体请查看互助需知
我知道了
×
提示
现在去查看 取消
×
提示
确定
0
微信
客服QQ
Book学术公众号 扫码关注我们
反馈
×
意见反馈
请填写您的意见或建议
请填写您的手机或邮箱
已复制链接
已复制链接
快去分享给好友吧!
我知道了
×
扫码分享
扫码分享
Book学术官方微信
Book学术文献互助
Book学术文献互助群
群 号:481959085
Book学术
文献互助 智能选刊 最新文献 互助须知 联系我们:info@booksci.cn
Book学术提供免费学术资源搜索服务,方便国内外学者检索中英文文献。致力于提供最便捷和优质的服务体验。
Copyright © 2023 Book学术 All rights reserved.
ghs 京公网安备 11010802042870号 京ICP备2023020795号-1