Effect of Fiber-Reinforced Composite Placement Site on Fracture Resistance of Premolar Teeth: An in vitro Study.

Abstract

Background: This study aimed to investigate the fracture behavior of upper premolars with deep MOD cavities that were restored with Ribbond resin-reinforced fibers (FRCs) placed in different orientations.

Methods: A total of 54 extracted maxillary premolars were randomly divided into nine groups. The experimental groups underwent MOD cavity preparation with or without root canal treatment, followed by FRCs placed in the pulpal floor, proximal walls, or both. Fracture resistance was tested using an Instron Machine. The samples were visually inspected to analyze the fracture mode.

Results: The highest fracture resistance was observed in intact teeth (1299.98 ± 284.66 MPa). Placing Ribbond fibers in the pulpal floor (1155.86 ± 244.21 MPa) or the proximal walls (1077.56 ± 260.60 MPa) significantly improved fracture resistance (p= <0.05), compared to cavities restored with only resin composite (804.58 ± 93.34 MPa). However, placing Ribbond fibers in both the pulpal and proximal walls did not enhance fracture resistance. In the MOD-RCT groups, fracture resistance was improved only when Ribbond fibers were placed in the pulpal floor and the proximal walls. Fracture mode analysis revealed a combined fracture in most of the groups.

Conclusion: This study concluded that using FRCs significantly improved the fracture resistance of MOD cavities in premolars and revealed that the placement site could be a determinant factor.