Evaluation of wear resistance of CrN, CrAlN, and TiAlN coatings deposited by multi-arc ion plating on spinning die of Cr12MoV

Abstract

This study successfully deposited CrN, CrAlN, and TiAlN coatings on the surface of Cr12MoV substrate using multi-arc ion plating (MAIP). The influence of phase composition and surface morphology on the hardness, adhesion strength, friction performance, and wear mechanisms of these coatings was investigated, with a comparative analysis of their wear resistance. Nanoindentation results revealed that the hardness (H) of CrN, CrAlN, and TiAlN coatings increased by 70.37%, 74.97%, and 75.64%, respectively, compared to the substrate. The hardness (H) and elastic modulus (E) were found to be positively correlated. CrAlN demonstrated superior resistance to deformation, reflected in its higher H/E and H3/E2 radios compared to the CrN and TiAlN. Adhesion tests showed that CrAlN had the strongest adhesion strength to the substrate, with an adhesion force of 81.55 N, representing a 14.78% and 8.46% improvement over CrN and TiAlN, respectively. Friction and wear tests identified CrAlN as having the lowest friction coefficient (0.389), attributed to its high hardness and strong adhesion. The wear mechanisms of CrAlN observed were primarily mild abrasive wear, oxidative wear, and adhesive wear. In comparison, CrN and TiAlN coatings exhibited higher friction coefficients of 0.424 and 0.391, respectively, due to their lower hardness and adhesion, which led to more severe oxidative and abrasive wear. Additionally, the TiAlN coating showed signs of brittle failure in wear scars, likely due to the formation of Al2O3 oxides during wear.