A Novel 3-Dimensional Printed Nanoceramic Hybrid Resin Fixed Lingual Retainer: Characterization and Mechanical Tests.

Introduction: An innovative retention protocol was developed to create a new 3D-printed fixed retainer employing SprintRay OnX nanoceramic hybrid resin. The feasibility and usability of the retainer were subsequently evaluated. Methods: Identification and characterization of SprintRay OnX was done using Fourier transform infrared spectroscopy (FTIR), scanning electron microscopy with energy dispersive X-ray (SEM-EDX), field emission scanning electron microscope (FE-SEM), X-ray diffraction (XRD), and flexural strength. Load-deflection and pull-out tests were conducted on the 3D-printed straight wires, with three distinct cross-sectional geometries: round (1 mm), oval (1 mm × 1.5 mm) and semielliptical (1 mm × 1.5 mm). Twisted G&H and coaxial Respond stainless steel multistrand retainers were used for comparison. In the load-deflection test, a three-point bending test (3PBT) was employed. For the pull-out test, the retainer wire was inserted into the composite, which was placed in a centrally located hole of an acrylic block; the retainer wire was subjected to a tensile force along its long axis. Results: Characteristic bands close to those of PMMA were observed in the FTIR spectra. SEM-EDX and XRD revealed a crystalline material with homogeneously distributed Yb element signals (19.4%). On FE-SEM micrographs, small clumps were displayed on smooth surfaces. The flexural strength and the flexural modulus were, respectively, 142.48 MPa and 7.842 GPa. All groups of 3D-printed wires exhibited significantly higher load-deflection levels than the multistrand wires (MSWs). Concerning pull-out forces, they fell in between twisted G&H (96 N) and coaxial Respond (48.09 N) retainer wires. The 3D-printed wires fractured cohesively without detachment from the adhesive, suggesting that the chemical bond was adequate for satisfactory wire integration, yet the wire's strength was compromised. Concerning the cross-sectional geometry, the load-deflection and the pull-out forces of 3D-printed oval and semielliptical wires were significantly higher than that of 3D-printed round wires, which was attributed to the larger cross-sections of the wires. Conclusion: Oval and semielliptical 3D-printed wires offered favorable features as lingual retainers.