Rigsite Thermal Treatment of Cuttings Enables Improved HSE Performance in 24-Well Campaign in the UK North Sea

On offshore rigs, oil-based mud (OBM) cuttings can create logistical and environmental risks. Onshore disposal requires costly transport, and bad weather can halt shipping operations. The liability for waste treated onshore belongs to the operator. Although offshore disposal removes this liability, UK North Sea regulations specify that oil on cuttings (OOC) must be less than 1%. (by weight?) A rigsite thermomechanical cuttings cleaner (TCC) applies high temperatures to help reduce OOC to less than 1% and recovers base oil and water for reuse. A TCC unit was installed on a semisubmersible rig to process OBM cuttings for a 24-well program. Mechanical action is applied directly to the cuttings by means of hammers that create friction, causing temperatures to exceed the boiling points of water and oil so that hydrocarbons are separated. The oil and water vapors are removed and condensed where the base oil and water are further separated and recovered. The TCC process on this rig was supported by vacuum-pump conveyance equipment and specialized storage tanks. Cuttings were no longer shipped to shore, and crane lifts associated with "skip-and-ship" operations were minimized significantly. The TCC unit processed 14,500 metric tons (MT) of OBM cuttings throughout the duration of the 24- well program. The total footage drilled with OBM was more than 160,000 ft. All cuttings were disposed offshore. Approximately 13,500 bbl of base oil (valued at USD 135/bbl) was recovered for reuse in the drilling fluid system. The TCC unit ran for a total of 3,500 hours with zero downtime or nonproductive time (NPT) associated with cuttings disposal. The average is approximately 150 operating hours per well. One important benefit was the dramatic reduction of skips handling and crane lifts, which provided safer working conditions for rig crews. On a conventional skip-and-ship operation, the operator would fill and transport up to 35 skips per day. This translates to 2,380 crane lifts per well that were unnecessary. Offloading delays caused by bad weather were no longer a factor, thus helping reduce uncertainty and saving valuable rig time. Processing this volume of drill cuttings offshore meant that more than 57,000 skip crane lifts were avoided. The TCC mobilization process for this program was executed efficiently by coordinating with quayside contractors (welders, platers, electricians, etc.) to complete much of the installation work scope onshore. Thermal treatment enables operators to address stringent offshore discharge regulations globally, excluding countries with zero discharge policies. Cost benefits include the following: No "wait on weather" time (rig day rate = USD 300,000)No dedicated vessels for transportNo quayside cuttings handlingNo trucking to treatment and disposal facilities Safety and environmental benefits add the following value: Reduced manual handling of skipsReduced crane liftsBase oil reuseLiability for waste ends at rigsite