Impediments to Refracturing Success in Shale Reservoirs

Stimulations in early horizontal wells in most shale plays are characterized by few and widely spaced perforation clusters, and low amounts of injected fracturing fluid and proppant. Low recovery from these wells has motivated refracturing although outcomes have been interpreted to range from successful to minimal impact based on operator specific evaluations. To tailor available technologies and improve quantification of upsides, there is need for mapping the spatial distribution of remaining resources and developing simpler but reliable analytical techniques. In this study, hydraulic fractures were assumed to be planar in a matrix with low porosity and ultra-low permeability. Consideration of natural fractures and their interaction with stimulation fluids led to addition of distributed fracture networks adjacent to the planar hydraulic fractures to define the composite fracture corridors. A sector model with the aforementioned architecture was used in reservoir simulation to investigate induced temporal and spatial drainage. These findings were used to explain the efficacy of widely used refracturing techniques and how post-refracturing reservoir response can be analyzed. Results from reservoir simulation showed remaining reserves were in the matrix between earlier placed hydraulic fractures aligned along initial perforation clusters, and beyond tips of hydraulic fractures. Upside from refracs could come from creation of new fractures in the matrix between earlier placed fractures and extension of tips of early fractures into virgin matrix. Assessment of these scenarios found the former to be optimal although depletion and existing perforations would limit the stimulation efficiency of new perforations. The second scenario would require large volumes of fracturing fluid to re-initiate fracture propagation. Yet this could trigger interference with offsets or affect drilling and stimulation of planned wells in adjacent acreage. For treatment efficiency, re-casing horizontal wells with competent liners and use of coiled tubing with straddle packers appears a better solution for bypassing old perforations. For the near wellbore and far field, re-stimulating new perforations at low injection rates could allow extension of fractures in virgin matrix surrounded by depleted strata. Real-time surveillance would be essential for mapping flow paths of refracturing fluid. For assessment of refracturing, actual and simulated flow exhibited persistent linear flow (PLF) that could be matched by Arps hyperbolic equation with a b value of 2. Incorporation of a novel fracture geometry factor (FGF) yielded an Arps-based equation that was tested on North American shale refracturing cases that often use post-treatment peak rate and wellhead pressure as measures of success. This study identified factors hindering the success of refracturing and proposed a modified Arps hyperbolic equation to analyze refracturing production data.