Effects of crosslinker concentration on curing process and performances of needled fiber preform reinforced phenolic aerogel composite using process simulation and comprehensive experiments

Abstract

A kind of needled quartz/carbon fiber preform reinforced phenolic aerogel composite (NQCF/PR) was fabricated through impregnating needled fiber preform with phenolic resin precursor solution, followed by sol–gel polymerization and solvent drying. The needled fiber preform serves as lightweight quasi-three-dimensional reinforcement, while phenolic aerogel matrix provides high porosity and low thermal conductivity. During fabrication of aerogel composite part using vacuum-assisted resin infusion process, distribution of crosslinker hexamethylenetetramine (HMTA) in precursor solution can be problematic, as precipitated crosslinker particles may be filtered by fibrous preform. In this study, the impact of HMTA filtration induced heterogeneous structure on subsequent curing process was investigated using process simulation. Temperature effects of sol–gel polymerization and solvent evaporation were considered through establishment of corresponding kinetic models. Impacts of heterogenous structure on distribution of temperature, resin curing degree and solvent conversion degree in large hemispherical aerogel composite structure were investigated. This leads to variations in gel network and pore structure of aerogel, thereby affecting final material performance. Based on experimental results, as HMTA concentration increases, compressive performance of NQCF/PR obviously increases. Among these, NQCF/PR with 4.7 wt% HMTA provides a balance of lightweight nature (0.25 g/cm³), excellent thermal insulation property (0.052 W·m⁻¹·K⁻¹) and compressive performance (strength of 0.35 MPa).