Finite element analysis of distraction osteogenesis with a new extramedullary internal distractor.

Abstract

Distraction osteogenesis (DO) is a bone regenerative maneuver, which is conventionally done with external fixators and, more recently, with telescopic intramedullary nails. Despite the proven effectiveness, external approaches are intrusive to the patient's life while intramedullary nailing damages the growth plates, making them unsuitable for pediatric patients. An internal DO plate fixator (IDOPF) was developed for pediatric patients to address these limitations. The objective of this study was to test the hypothesis that the IDOPF can withstand a partial weight bearing scenario and create a favorable mechanical microenvironment at the osteotomy gap for bone regeneration as the device elongates. A finite element model of a surrogated long bone diaphysis osteotomy fixation by means of the IDOPF was created and subjected to axial compression, bending and torsion. As the osteotomy gap increased from 2 mm to 20 mm, under compression, The average axial interfragmentary strains decreased from 2.33% to 0.35%. Stress increased from 179 MPa to 281 MPa at the contact interfaces of the telescopic compartments, which exceeded the endurance limit of stainless steel (270 MPa) but was below its yield limit (415 MPa). These results demonstrate, that the IDOPF can withstand a partial load bearing scenario and provide a stable biomechanical environment conductive to bone healing. However, high contact stresses at the telescopic interfaces of the device are likely to cause wear, as is frequently reported in telescopic fixators. This study is a step towards refining the IDOPF design for clinical use.