Design & Development of Electro Hydraulic Control Valve for Integration of Hoist and Steering System of a Dump Truck (35t)

The intent of this paper is to propose a system to control the steering operation and hoist operation of the Dump truck through combination of electro hydraulic valves and priority valve housed in Integrated manifold block. Electro hydraulic control valve(EHCV), and Electronic controller unit (ECU) for steering and hoist operation of the dump truck. The orbitrol valve consists of load sensing line, when the Orbitrol valve sense an effort on the steering wheel by the operator, the load sensing line will give a feedback signal to the electro hydraulic valve, which will divert the pressurized hydraulic oil to the steering system for steering operation, else the hydraulic oil is available for hoist operation. The hoist operation is control through Electronic Controller Unit (ECU). If there is no signal from the controller for hoist operation the hydraulic oil will flow back to tank. The Electronic controller will energize the combination of solenoid operated valves, depending upon the input received from operator through the momentary switch (Raise Switch, Lower/Float Switch, Hold Switch) mounted inside the cabin, which will allow the flow of pressurized hydraulic oil to the hoist cylinder for body raise and lower operation through electro hydraulic control valve. The electronic controller memorizes the signal from momentary switch and energizes the solenoids as per the logic till the next input signal receive by controller.