INFLUENCE OF THE RATE OF IRON HEXATIANOFERRATE ON ITS SORPTION ABILITY IN RELATION TO SILVER, INDIUM AND GALLIUM CATIONS

The processing of phosphorites into elemental phosphorus is accom-panied by the formation of waste - cotrile "milk", in which indium, gallium, and silver are present. This waste can be considered as a cheap raw material for the production of rare and precious metals. In the scientific literature there are data on the sorption capacity of hexacyano-ferrates of iron, which has a crystal lattice with a channel diameter from 3.0 to 3.5Å. Investigation of the sorption process in the model system "Fe4[Fe(CN)6]3·10H2O - Ag+- In3+- Ga3+ - H2O" depending on the norm of iron hexacyanoferrate (sorbent). The initial concentration of silver, indium and gallium ions and their residual content in solutions were determined using the atomic absorption spectrophotometer "PerkinElmer Analyst 400" (USA). The microstructure of the initial iron hexacyanoferrate and iron hexacyano-ferrate, after sorption, was studied on the CarlZeissFESEM and JEOL brand "JXA-8230" (Japan). With a ratio to T:W equal to 1.75-2.5:100, the degree of sorption of Ag+ with iron hexacyanoferrate is 99.5 and 99.8 %. The highest degree of sorption (96.75%) of In3+ ions can be obtained with a sorbent weighing 3 g per 100 g of solution at 60oC. A high degree of sorption of Ga3+ cations is achieved at low (0.5:100 wt. h.) and high (3:100 wt. h.) consumption of iron hexacyanoferrate. It was revealed that iron hexacyanoferrate exhibits sorption properties simultaneously with respect to mono- and trivalent metals, and the basic laws of their sorption were established.