Journal of environmental sciences最新文献

Antimony (Sb) is a toxic and carcinogenic element that often enters soil in the form of antimony trioxide (Sb₂O₃) and coexists with manganese (Mn) in weakly alkaline conditions. Mn oxides such as birnessite have been found to promote the oxidative dissolution of Sb₂O₃, but few researches concerned the co-transformations of Sb₂O₃ and Mn(II) in environment. This study investigated the mutual effect of abiotic oxidation of Mn(II) and the coupled oxidative dissolution of Sb₂O₃. The influencing factors, such as Mn(II) concentrations, pH and oxygen were also discussed. Furthermore, their co-transformed mechanism was also explored based on the analysis of Mn(II) oxidation products with or without Sb₂O₃ using XRD, SEM and XPS. The results showed that the oxidative dissolution of Sb₂O₃ was enhanced under higher pH and higher Mn(II) loadings. With a lower Mn(II) concentration such as 0.01 mmol/L Mn(II) at pH 9.0, the improved dissolution of Sb₂O₃ was attributed to the generation of dissolved intermediate Mn(III) species with strong oxidation capacity. However, under higher Mn(II) concentrations, both amorphous Mn(III) oxides and intermediate Mn(III) species were responsible for promoting the oxidative dissolution of Sb₂O₃. Most released Sb (∼72%) was immobilized by Mn oxides and Sb(V) was dominant in the adsorbed and dissolved total Sb. Meanwhile, the presence of Sb₂O₃ not only inhibited the removal of Mn(II) by reducing Mn(III) to Mn(II) but also affected the final products of Mn oxides. For example, amorphous Mn oxides were formed instead of crystalline Mn(III) oxides, such as MnOOH. Furthermore, rhodochrosite (MnCO₃) was formed with the high Mn(II)/Sb₂O₃ ratio_, but without being observed in the low Mn(II)/Sb₂O₃ ratio. The results of study could help provide more understanding about the fate of Sb in the environment and the redox transformation of Mn.

A novel Mg-based bimetal reagent (Mg/Cu) was used as an enhanced reductive system to degrade insensitive munition 2,4-dinitroanisole (DNAN), a contaminant found in energetic-laden waste. Degradation of DNAN was significantly impacted by dissolved oxygen and studied in anoxic and oxic bimetal systems (i.e., purging with N₂, air, or O₂ gas). Degradation occurred through sequential nitroreduction: first one nitro group was reduced (ortho or para) to form short-lived intermediates 2-amino-4-nitroanisole or 4-amino-2-nitroanisole (2-ANAN or 4-ANAN), and then subsequent reduction of the other nitro group formed 2,4-diaminoanisole (DAAN). The nitro-amino intermediates demonstrated regioselective reduction in the ortho position to 2-ANAN; Regioselectivity was also impacted by the anoxic/oxic environment. Under O₂-purging DNAN degradation rate was slightly enhanced, but most notably O₂ significantly accelerated DAAN generation. DAAN also further degraded only in the oxygenated Mg/Cu system. Adsorption of DNAN byproducts to the reagent occurred regardless of anoxic/oxic condition, resulting in a partition of carbon mass between the adsorbed phase (27%-35%) and dissolved phase (59%-72%). Additional surface techniques were applied to investigate contaminant interaction with Cu. Density functional theory (DFT) calculations identified preferential adsorption structures for DNAN on Cu with binding through two O atoms of one or both nitro groups. X-ray absorption spectroscopy (XAS) measurements determined the oxidation state of catalytic metal Cu and formation of a Cu-O-N bond during treatment. Laser desorption ionization mass spectrometry (LDI-MS) measurements also identified intermediate 2-ANAN adsorbed to the bimetal surface.

Plants have to cope with several abiotic stresses, including salinity and heavy metals (HMs). Under these stresses, several extracts have been used as effective natural biostimulants, however, the use of Spirulina platensis (SP) extract (SPE) remains elusive. The effects of SPE were evaluated as soil addition (SA) and/or foliar spraying (FS) on antioxidant defenses and HMs content of common bean grown in saline soil contaminated with HMs. Individual (40 or 80 mg SPE/hill added as SA or 20 or 40 mg SPE/plant added as FS) or integrative (SA+FS) applications of SPE showed significant improvements in the following order: SA-80+FS-40 > SA-80+FS-20 > SA-40+FS-40 > SA-40+FS-20 > SA-80 > SA-40 > FS-40 > FS-20 > control. Therefore, the integrative SA+FS with 40 mg SP/plant was the most effective treatment in increasing plant growth and production, overcoming stress effects and minimizing contamination of the edible part. It significantly increased plant growth (74%–185%) and yield (107%–227%) by enhancing net photosynthetic rate (78.5%), stomatal conductance (104%), transpiration rate (124%), and contents of carotenoids (60.0%), chlorophylls (49%–51%), and NPK (271%–366%). These results were concurrent with the marked reductions in malondialdehyde (61.6%), hydrogen peroxide (42.2%), nickel (91%–94%), lead (80%–9%), and cadmium (74%–91%) contents due to the improved contents of glutathione (87.1%), ascorbate (37.0%), and α-tocopherol (77.2%), and the activities of catalase (18.1%), ascorbate peroxidase (18.3%), superoxide dismutase (192%), and glutathione reductase (52.2%) as reinforcing mechanisms. Therefore, this most effective treatment is recommended to mitigate the stress effects of salinity and HMs on common bean production while minimizing HMs in the edible part.

Due to the combined effect of sluices and sea tide, the sluice-controlled coastal plain river would be characterized by both trophic state and salinity gradients, affecting the spatiotemporal optical properties of dissolved organic matter (DOM). In this study, we investigated the spatiotemporal variation of water quality parameters and optical properties of DOM in the Haihe River, a representative sluice-controlled coastal plain river in Tianjin, China. A significant salinity gradient and four trophic states were observed in the water body of the Haihe River. Two humic- and one protein-like substances were identified from the DOM by the three-dimensional fluorescence spectra combined with the parallel factor (PARAFAC) analysis. Pearson's correlation analysis and redundancy analysis (RDA) showed that the salinity significantly affected the abundance of chromophoric DOM (CDOM) but did not cause significant changes in the fluorescence optical characteristics. In addition, the effect of Trophic state index (TSI) on the CDOM abundance was greater than that on the fluorescence intensity of fluorescent dissolved organic matter (FDOM). In the water body with both salinity and trophic state gradients, TSI posed a greater influence than salinity on the CDOM abundance. Our results fill the research gap in spatiotemporal DOM characteristics and water quality variation in water bodies with both salinity and trophic state gradients. These results are beneficial for clarifying the joint influence of saline intrusion and sluices on the DOM characteristics and water quality in sluice-controlled coastal plain rivers.

Thallium contamination in water can cause great danger to the environment. In this study, we synthesized manganese oxide-coated sand (MOCS) and investigated the transport and retention behaviors of Tl(I) in MOCS under different conditions. Characterization methods combined with a two-site nonequilibrium transport model were applied to explore the retention mechanisms. The results showed that Tl(I) mobility was strongly inhibited in MOCS media, and the retention capacity calculated from the fitted model was 510.41 mg/g under neutral conditions. The retention process included adsorption and oxidative precipitation by the manganese oxides coated on the sand surface. Cotransport with the same concentration of Mn(II) led to halving Tl(I) retention due to competition for reactive sites. Enhanced Tl(I) retention was observed under alkaline conditions, as increasing pH promoted electronegativity on the media surface. Moreover, the competitive cation Ca²⁺ significantly weakened Tl(I) retention by occupying adsorption sites. These findings provide new insights into understanding Tl(I) transport behavior in water-saturated porous media and suggest that manganese oxide-coated sand can be a cost-effective filter media for treating Tl-contaminated water.

Chlorine-based disinfectants are widely used for disinfection in wastewater treatment. The mechanism of the effects of chlorinated disinfection by-products on cyanobacteria was unclear. Herein, the physiological effects of chloroacetic acid (CAA) on Microcystis aeruginosa (M. aeruginosa), including acute toxicity, oxidative stress, apoptosis, production of microcystin-LR (MC-LR), and the microcystin transportation-related gene mcyH transcript abundance have been investigated. CAA exposure resulted in a significant change in the cell ultrastructure, including thylakoid damage, disappearance of nucleoid, production of gas vacuoles, increase in starch granule, accumulation of lipid droplets, and disruption of cytoplasm membranes. Meanwhile, the apoptosis rate of M. aeruginosa increased with CAA concentration. The production of MC-LR was affected by CAA, and the transcript abundance of mcyH decreased. Our results suggested that CAA poses acute toxicity to M. aeruginosa, and it could cause oxidative damage, stimulate MC-LR production, and damage cell ultrastructure. This study may provide information about the minimum concentration of CAA in the water environment, which is safe for aquatic organisms, especially during the global coronavirus disease 2019 pandemic period.

Bacterial infections have become a great threat to public health in recent years. A primary lysozyme is a natural antimicrobial protein; however, its widespread application is limited by its instability. Here, we present a poly (N-isopropylacrylamide) hydrogel inverse opal particle (PHIOP) as a microcarrier of lysozyme to prolong and enhance the efficiency against bacteria. This PHIOP-based lysozyme (PHIOP-Lys) formulation is temperature-responsive and exhibits long-term sustained release of lysozyme for up to 16 days. It shows a potent antibacterial effect toward both Escherichia coli and Staphylococcus aureus, which is even higher than that of free lysozyme in solution at the same concentration. PHIOPs-Lys were demonstrated to effectively inhibit bacterial infections and enhance wound healing in a full-thickness skin wound rat model. This study provides a novel pathway for prolonging the enzymatic activity and antibacterial effects of lysozyme.

Surfactant enhanced elution is an effective method for removing hydrophobic organic pollutants from soils. The key to the development of leaching technology is selective removal of targeted pollutants in soil washing effluent and recycling of surfactant solutions. In this study, a molecular imprinting technique was applied to selectively sorb polybrominated diphenyl ethers (PBDEs) in soil washing effluent. The novel molecular imprinted polymers (MIPs) using different template molecules were synthesized by precipitation polymerization. Adsorption behaviors and mechanisms of MIPs were studied through experiments and theoretical calculations. The results show that 4-bromo-4′-hydroxybiphenyl and toluene can be effective imprinting molecule for MIPs synthesis. The maximal adsorption capacity of selected dummy molecular imprinted polymer (D₁-MIP) was 1032.36 µmol/g, and that of part molecular imprinted polymer (P-MIP) was 981.13 µmol/g. Their imprinting factors in 5 PBDEs adsorption ranged from 2.13 to 5.88, the recovery percentage of Triton X-100 can reach 99.09%, confirming the feasibility of reusing surfactant. Various PBDEs could be removed by MIPs, and Quantitative Structure Property Relationship analysis revealed that PBDEs’ molecular volume, planarity, polarity, and hydrophobicity have major influences on their adsorption performance. DFT calculation revealed that Van der Waals force and hydrogen bonding played important roles during selective adsorption. These results can provide effective theoretical guidance for surfactant enhanced soil elution in practical engineering applications.

Pathogenic microbes with antibiotic resistance can thrive on municipal solid waste as nutrients and be aerosolized and transported to vicinities during waste disposal processes. However, the characterization of pathogenic bioaerosols and assessment of their exposure risks are lacking. Herein, particle size, concentration, activity, antibiotic resistance, and pathogenicity of airborne microorganisms were assessed in different sectors of a typical landfill. Results showed that active sector in downwind direction has the highest bioaerosol level (1234 CFU/m³), while residential area has the highest activity (14.82 mg/L). Botanical deodorizer from mist cannon can effectively remove bioaerosol. Most bioaerosols can be inhaled into respiratory system till bronchi with sizes ranging from 2.1−3.3 and 3.3−4.7 µm. Pathogenic bacteria (Bacilli, Bacillus, and Burkholderia-Paraburkholderia) and allergenic fungi (Aspergillus, Cladosporium, and Curvularia) prevailed in landfill. Although high abundance of microbial volatile organic compounds (mVOCs) producing bioaerosols were detected, these mVOCs contributed little to odor issues in landfill. Notably, surrounding areas have higher levels of antibiotic-resistance genes (ARGs) than inner landfill with tetC, acrB, acrF, mdtF, and bacA as dominant ones. Most ARGs were significantly correlated with bacterial community, while environmental parameters mainly influenced fungal prevalence. These findings can assist in reducing and preventing respiratory allergy or infection risks in occupational environments relating to waste management.

The selective recovery of copper from strongly acidic wastewater containing mixed metal ions remains a significant challenge. In this study, a novel reagent zinc dimethyldithiocarbamate (Zn(DMDC)₂) was developed for the selective removal of Cu(II). The removal efficiency of Cu(II) reached 99.6% after 120 min reaction at 30°C when the mole ratio Zn(DMDC)₂/Cu(II) was 1:1. The mechanism investigation indicates that the Cu(DMDC)₂ products formed as a result of the displacement of Zn(II) from the added Zn(DMDC)₂ by Cu(II) in wastewater, due to the formation of stronger coordination bonds between Cu(II) and the dithiocarbamate groups of Zn(DMDC)₂. Subsequently, we put forward an innovative process of resource recovery for strongly acidic wastewater. Firstly, the selective removal of Cu(II) from actual wastewater using Zn(DMDC)₂, with a removal efficiency of 99.7%. Secondly, high-value CuO was recovered by calcining the Cu(DMDC)₂ at 800°C, with a copper recovery efficiency of 98.3%. Moreover, the residual As(III) and Cd(II) were removed by introducing H₂S gas, and the purified acidic wastewater was used to dissolve ZnO for preparation of valuable ZnSO₄·H₂O. The total economic benefit of resource recovery is estimated to be 11.54 $/m³. Accordingly, this study provides a new route for the resource recovery of the treatment of copper-containing acidic wastewater.