Pesquisa odontologica brasileira = Brazilian oral research最新文献

The purpose of this study was to evaluate the correlation between degree of conversion and microhardness in dental composites, as well as the effect of the inorganic content and type of photo-curing unit on these parameters. Three indirect composites (Artglass, Solidex and Zeta LC) were polymerized by means of three different laboratorial units (UniXS, Solidilite and an experimental device). For each material, fifteen samples were prepared using a metal matrix. The degree of conversion was analyzed by means of infrared spectroscopy, and microhardness was also assessed. The inorganic content was measured by means of thermogravimetric analysis (TGA). The Pearson s test was carried out in order to determine correlations. The degree of conversion of Artglass ranged from 37.5% to 79.2%, and its microhardness, from 32.4 to 50.3 (r = 0.904). The degree of conversion of Solidex ranged from 41.2% to 60.4%, and its microhardness, from 33.3 to 44.1 (r = 0.707). The degree of conversion and the microhardness of Zeta LC ranged from 62.0% to 78.0% and from 22.6 to 33.6, respectively (r = 0.710). It was concluded that the utilization of different photo-curing units caused variations on the degree of conversion, as a result of specific characteristics of each unit. For each material, there was strong correlation between the degree of conversion and microhardness. In addition, when different materials were compared, microhardness was more affected by filler content than by the degree of conversion.

The aim of this study was to assess the periodontal condition and the presence of putative periodontal pathogens in 30 Brazilian mothers, aging 21-40 years (28.4 4.49 years), and in their children, aging 5-6 years, since mothers can be a source of pathogens and, thus, influence their children's bacteriological and clinical condition. Besides assessing the plaque index (PI), gingival index (GI) and pocket probing depth (PD), the survey analyzed four subgingival dental plaque samples from mothers and children, as well as a sample of stimulated saliva from mothers. Those samples were analyzed by means of the slot immunoblot (SIB) technique, in order to determine the presence of Actinobacillus actinomycetemcomitans (Aa), Prevotella nigrescens (Pn), Porphyromonas gingivalis (Pg) and Treponema denticola (Td). The mean values and standard deviations of the evaluated clinical variables for mothers and children were, respectively: 1.86 0.67 and 1.64 0.68 for PI, and 1.24 0.67 and 0.82 0.37, for GI. Only for mothers, the total PD was 1.81 0.69 mm, and the PD of four sites was 4.03 1.40 mm. The Wilcoxon test revealed significant difference (p < 0.05) between mothers and their children only as to GI. The most prevalent bacteria in mothers were, in decreasing order: Aa, Pn, Pg and Td. The children presented patterns of oral hygiene and bacterial profiles similar to those of their mothers, in spite of the fact that most of them did not present enough subgingival plaque for testing. The comparison between mothers' subgingival dental plaque and saliva samples revealed statistically significant differences (p < 0.05) for all bacteria, with greater positivity and scores in the saliva, which demonstrates that it is an indicator of oral colonization and can work as a vehicle for the transmission of periodontopathogens from mothers to their children.

The aim of this study was to evaluate the influence of light intensity and the influence of the color of a composite resin on Knoop hardness. Samples were confected utilizing polyester matrices with 6 mm of diameter and 2 mm of depth. The matrices were filled with composite resin (Fill Magic - Vigodent), colors A3, B3, C3, D3 and I, and light-cured by means of an Elipar light-curing unit in three different light intensities: 450 mW/cm2, 800 mW/cm2 and an increasing intensity setup of 100 mW/cm2 to 800 mW/cm2. Ninety test specimens were confected, with the standard curing time of 40 seconds. The specimens were stored at 37 +/- 1 degrees C and immersed in distillate water. The Knoop test was carried out in superficial and deep areas of the specimens. The results revealed that there was no statistical difference (Tukey) between the tested colors. However, there was statistical difference between different light intensities. The authors concluded that the color of the composite resin did not influence Knoop hardness and that the progressive intensity setup led to the best Knoop hardness.

The aim of this study was to evaluate the influence of techniques of composite resin polymerization and insertion on microleakage and microhardness. One hundred and eighty class II cavities were prepared in bovine teeth and assigned to six groups: G1 - bulk filling + conventional polymerization; G2 - bucco-lingual increments + conventional polymerization; G3 - bulk filling + soft-start polymerization; G4 - bucco-lingual increments + soft-start polymerization; G5 - bulk filling + progressive polymerization; G6 - bucco-lingual increments + progressive polymerization. All cavities were restored with the Z100/Single Bond system (3M). After thermocycling, the samples were immersed in 2% methylene blue dye solution for 4 hours. Half of the samples were embedded in polystyrene resin, and Knoop microhardness was measured. The Kruskal-Wallis test did not reveal statistical differences (p > 0.05) between the polymerization and insertion techniques as to microleakage. Regarding microhardness, the two-way ANOVA and the Tukey test did not reveal statistical differences between the restorative techniques (p > 0.05), but progressive polymerization (G5 and G6) was associated with smaller Knoop microhardness values (p < 0.05): G = 144.11; G2 = 143.89; G3 = 141.14; G4 = 142.79; G5 = 132.15; G6 = 131.67. It was concluded that the evaluated polymerization and insertion techniques did not affect marginal microleakage, but a decrease in microhardness occurred when progressive polymerization was carried out.

The aim of this study was to evaluate, in vitro, the effect of nicotine on the viability and morphology of fibroblasts from a continuous lineage. Two experimental groups were prepared, with different drug dosages (0 - control, 10 microgram 100 microgram, 0.5 mg, 1 mg) and conditioning time (1 and 24 hours). Twelve-well microplates were utilized. Each well received 2 ml of fresh culture medium and 1 ml of a solution containing 1 x 10(5) cells/ml. Nicotine was then added to the wells, at the tested concentrations. After the incubation period, cell viability was assessed by means of 0.4% trypan blue staining. Cell viability and morphology were assessed in an inverted microscope, by a single examiner, who was blind as to the experimental groups. The experiment was repeated 5 times. Regarding morphology, in the 1-hour conditioned group there was statistically significant difference between the control group and the group with the greatest dose of nicotine. These differences were also observed between the control group and all nicotine groups after 24 hours. The results of the Kruskal-Wallis test revealed that more unviable cells were found in the groups exposed to nicotine, in comparison with the control group, both after 1 and 24 hours of conditioning (p < 0.05). Moreover, with increasing doses of nicotine there was a directly proportional increase in the number of unviable cells, both after 1 and 24 hours of exposure (p = 0.0053 and p = 0.00001, respectively). The conclusion of this study is that nicotine can alter, in vitro, the viability and morphology of fibroblasts in a manner proportional to the dose and time of exposure.

The purpose of the present study was to evaluate the bond strength of four adhesive systems to dentin. Twelve human third molars had their occlusal enamel removed in order to expose a flat dentinal surface, on which the adhesive procedures were carried out. The teeth were divided into four groups, according to the employed adhesive system and composite resin: Group 1 - Single Bond + P60 (SB); Group 2 - Bond 1 + Surefil (B1); Group 3 - Prime Bond NT + Alert (NT); and Group 4 - Prime Bond 2.1 + TPH (2.1). After 24 h in distilled water at 37 degrees C, the teeth were longitudinally sectioned in two perpendicular directions in order to obtain parallelogram-shaped specimens with a cross-sectional area of 0.8 mm2 and 10 mm of length, on the average. The test specimens were submitted to microtensile test. The data were submitted to ANOVA (alpha = 0.05), which revealed no differences between the groups, although the analysis of the specimens that presented early fracture evidenced the lower sensitivity of the SB system.

The aim of this study was to assess the prevalence of caries and risk factors in outpatients of the Pediatric Ambulatory of the Pedro Ernesto University Hospital aging up to 36 months. After signing informed consent forms, the parents answered a structured questionnaire in order to evaluate risk factors for dental caries, including socioeconomic status, oral hygiene and dietary habits. A single investigator carried out the dental examination which assessed the presence of caries, biofilm and gingival bleeding. The data were analyzed by means of the Epi Info program, utilizing the chi-squared test. The children's mean age was 22.9 months. The prevalence of caries, including white spot lesions, was 41.6%, and the mean def-s was 1.7 (+/- 2.5). The most affected teeth were the maxillary incisors, and the most common lesion was the white spot. No significant associations were found between the prevalence of caries and socioeconomic status, frequency of oral hygiene, nocturnal bottle- and breast-feeding or cariogenic food and beverage intake during the day. However, the association between caries and oral hygiene quality (dental biofilm) was statistically significant (p < 0.001). The results suggest that the presence of a thick biofilm was the most important factor for the occurrence of early childhood caries in the evaluated sample.

External cervical root resorption is one of the disadvantages of the bleaching procedure. There are several mechanisms that may be responsible for causing resorption, such as the chemical and physical action of the utilized materials and the morphology of the cementoenamel junction. The purpose of this study was to investigate the presence of a communication between the pulp chamber and the external root surface. The investigation was carried out by means of pH tests and measurement of dye infiltration into cervical dentin after the bleaching procedure. Thirty-four human permanent incisors were submitted to endodontic treatment. The teeth were assigned to three experimental groups, according to the level at which the filling was cut, and to the sealing of the root canal entrance with glass ionomer cement. Sodium perborate and 30% hydrogen peroxide were utilized for bleaching. pH readings were carried out after 30 minutes, 24 h, 48 h and 72 h from the beginning of the procedure. The teeth were immersed in 0.5% basic fuchsin for 24 h in order to determine possible differences in the permeability of cervical dentin. The results revealed that pH tended to change when the root filling was cut at the entrance of the canal, when 2 mm of the filling were removed, and when the canal entrance was sealed with glass ionomer. Dentinal permeability increased in the three experimental groups, in comparison with the control group. These slight differences may suggest a communication between the pulp chamber and the external root surface.

Hydroxyapatite (HA) has been used in orthopedic, dental, and maxillofacial surgery as a bone substitute. The aim of this investigation was to study the effect of surface topography produced by the presence of microporosity on cell response, evaluating: cell attachment, cell morphology, cell proliferation, total protein content, and alkaline phosphatase (ALP) activity. HA discs with different percentages of microporosity (< 5%, 15%, and 30%) were confected by means of the combination of uniaxial powder pressing and different sintering conditions. ROS17/2.8 cells were cultured on HA discs. For the evaluation of attachment, cells were cultured for two hours. Cell morphology was evaluated after seven days. After seven and fourteen days, cell proliferation, total protein content, and ALP activity were measured. Data were compared by means of ANOVA and Duncan's multiple range test, when appropriate. Cell attachment (p = 0.11) and total protein content (p = 0.31) were not affected by surface topography. Proliferation after 7 and 14 days (p = 0.0007 and p = 0.003, respectively), and ALP activity (p = 0.0007) were both significantly decreased by the most irregular surface (HA30). These results suggest that initial cell events were not affected by surface topography, while surfaces with more regular topography, as those present in HA with 15% or less of microporosity, favored intermediary and final events such as cell proliferation and ALP activity.

This study evaluated the disclosing ability, removal facility and antimicrobial effect of biofilm disclosing agents applied on complete dentures. Disclosing ability was evaluated by means of the visual method. The solutions were applied on the internal surface of dentures. After being photographed, the dentures were brushed with denture-specific brush and dentifrice and photographed again. The obtained slides were projected on paper (10 X amplification) and the total and stained surfaces were outlined with graphite, cut off and weighed, in order to assess removal facility. The evaluation of antimicrobial effects was carried out by means of the method of diffusion in agar, and the results were obtained by measuring the length of the halos and rings. In terms of disclosing ability, the best solutions were 0.05% methylene blue, 5% erythrosin, 1% sodic fluorescein, Replak and 1% neutral red. One percent eosin, 1% sodic fluorescein and 5% erythrosin were the most easily removed solutions. One percent eosin, 5% erythrosin, 1% sodic fluorescein, 0.3% proflavine, Replak and 1% neutral red presented no antimicrobial effect. The solutions which presented the greatest disclosing ability and removal facility as well as absence of antimicrobial effect - which are essential requirements in the assessment of hygiene methods and guidance on oral health - were 1% eosin, 1% neutral red and 5% erythrosin.