JAPCA最新文献

Some consequences of acute exposure to ozone are best measured in studies of human respiratory responses in controlled exposure chambers. These studies typically examine relationships between exposures to alternative pollutant concentrations and indicators of lung function as measured by spirometry, such as forced expiratory volume in one second, FEV1. However, the association of respiratory morbidity with these changes in lung function is not well established. To gain a better understanding of the relationship between ozone-related changes in pulmonary function and respiratory symptoms, data from several clinical studies have been reanalyzed. Logistic regression models were used to determine the quantitative relationship between changes in FEV1 and the probability of a mild or moderate lower respiratory symptom. Models were developed that corrected for repeated sampling of individuals and both population-averaged and subject-specific effects were determined. The results indicate the existence of a strong and consistent quantitative relationship between changes in lung function and the probability of a respiratory symptom. Specifically, a 10 percent reduction in FEV1 is associated with a 15 percentage point increase in the probability of a mild, moderate or severe lower respiratory symptom and a 6 percentage point increase in the probability of a moderate or severe lower respiratory symptom.

Seventeen non-smoking young men served as subjects to determine the alteration in carboxyhemoglobin (COHb) concentrations during exposure to 0 or 9 ppm carbon monoxide for 8 hours (CO) at sea level or an altitude of 2134 meters (7000 feet) in a hypobaric chamber. Nine subjects rested during the exposure and 8 exercised for 10 minutes of each exposure hour at a mean ventilation of 25 L (BTPS). All subjects performed a maximal aerobic capacity test at the completion of their respective exposures. Carboxyhemoglobin concentrations fell in all subjects during their exposures to 0 ppm CO at sea level or 2134 m. During the 8-h exposures to 9 ppm CO, COHb rose linearly from approximately 0.2 percent to 0.7 percent. No significant differences in uptake were found whether the subjects were resting or intermittently exercising during their 8-h exposures. COHb levels attained were similar at both sea level and 2134 m. Maximal aerobic capacity was reduced approximately 7-10 percent consequent to altitude exposure during 0 ppm CO exposures. These values were not altered following exposure for 8 h to 9 ppm CO in either the resting or exercising subjects.

A method for the high resolution, high sensitivity analysis of polluted air for individual organic compounds is described. Samples collected from 50 mL of ambient air at 87 K (liquid argon) are injected without use of a valve into a silica capillary column which is then temperature programmed from -30 degrees C to 180 degrees C. Hydrocarbons (4 to 10 carbons) as well as carbonyl compounds, chlorinated compounds and terpenes can be identified and quantified. The detection limit, not strongly dependent on carbon number, is estimated to be 0.3 ppbc in a 50 mL sample. Use of small samples eliminates the need to remove water vapor, a procedure which might jeopardize sample integrity.

Regulation to control air emissions of toxic organic compounds require the collection and analysis of effluent gas from low level sources such as hazardous waste incinerators. The standard SW-846 Method specifies the use of Tenax and Tenax/charcoal adsorbent traps for collection of volatile organics from incinerators. This study evaluates passivated stainless steel canisters as an alternative to adsorbent traps to eliminate some of the problems associated with adsorbent sampling. Initially the stability of 18 nonpolar, volatile organic compounds was determined in Summa-treated stainless steel canisters with greater than 100 ppmv HCl and saturated with water vapor. All 18 components were stable for a two-week period; however, an interference caused a 10-fold increase in the FID response of trichloroethylene, toluene, and chlorobenzene. No interference of the ECD response was found for any of the 11 compounds detected with the ECD including trichloroethylene. A pilot scale incinerator was sampled using canisters, and the destruction efficiency of 1,1,1-trichloroethane was determined at a concentration of less than 0.5 ppbv while determining 1,1-dichloroethylene, the major product of incomplete combustion, at a concentration of 8000 ppbv from the same sample.

Potential health risks of exposure to emissions of a yeast and penicillin production plant were investigated by measuring viable particles and protein contents of particles in ambient air. The results showed a clear decrease of the downwind number of yeast colony-forming units with increasing distance from the source. Upwind the number of yeast colony-forming units was zero. Identification showed that nearly all yeast were of the species Saccharomices cerevisiae. Such a trend could not be found for the total number of colony-forming units (yeasts, molds, and bacteria) although the upwind concentration was slightly lower than the downwind concentration. The downwind protein concentration was significantly elevated compared to the upwind concentration.

The present National Ambient Air Quality Standard for ozone has many statistical problems, including use of extreme values which have inherent large fluctuations, a compliance test that can gradually lower the target of the design value below the standard level, and inconsistencies between the number-of-exceedances criterion and the design value. The above problems can be avoided or minimized by using a more robust statistic, such as the 95th percentile, and applying a statistical compliance test, without sacrificing the stringency of the standard. Analysis of EPA's ozone data shows that the annual 95th percentiles and their three-year means have less variability than the annual second highest values and the fourth highest values in three years, respectively. At t test for the mean of the annual 95th percentiles is proposed for compliance testing not only to preserve the averaging concept of the present standard, but also to take account of ozone concentration fluctuations in order to increase the stability of the compliance status of a site or a Metropolitan Statistical Area. A procedure is provided to adjust the level of the 95th-percentile standard so that the stringency of the present standard is preserved.